Alternate Character Art | Pulp Fiction "Double Tap" Topper Mod

Alternate character art mod for Pulp Fiction "Double Tap" topper from The Electric Playground ( https://www.teppinball.com/store/p/pulp-topper ). Easy installation fits over existing character art. 

INSTALLATION (see pictures)

1) Remove the backing paper on both pieces

2) With the included 2MM Allen, remove the 2 screws holding on the 2 characters. You may need to hold the bracket in the back. 

3) The new art has a slot, start by sliding the slot over the wireform ramp from the top, then rotate it into place. 

4) Once it’s in place make sure the 3 offset holes go over the existing hardware in 3 places. Getting those 3 holes aligned means that the final screw hole is aligned. 

5) Replace the screw you removed earlier. The alignment can be a bit tricky, note that the angle of the hole is perpendicular to the art. 

6) As you tighten the screw, make sure the plastics align. You can “pinch” the head of each character to ensure the plastics align. 

7) Enjoy!